#8 High Temp Silicone Chimney Boot for Metal Roof Vent Pipes, Roof Pipe Flashing Boot for Pipe OD 7" - 13" Included Roofing Screws & Hex Socket, Metal Square Base Flexible Jack Pipes Flashing
€22.79
Preis bei Onlinekauf
Kostenloser Versand
30 Tage kostenlose Rückgabe
Verkauft und versendet von noticiasdelaquinta.com.ar
Wir bemühen uns, Ihnen genaue Produktinformationen anzuzeigen. Hersteller, Lieferanten und andere stellen die hier gezeigten Angaben bereit.
€22.79
Preis bei Onlinekauf
Kostenloser Versand
30 Tage kostenlose Rückgabe
Verkauft und versendet von noticiasdelaquinta.com.ar
30 Tage kostenlose Rückgabe Details
Produktdetails
| Artikelnummer | 226058407 | Erscheinungsdatum | 2026/05/09 | Listenpreis | €22.79 | Modellnummer | 226058407 | ||
|---|---|---|---|---|---|---|---|---|---|
| Kategorie | |||||||||
- #8 SIZE – FITS 7"-13" OD PIPES: Designed for metal roof penetrations on chimneys, wood stoves, exhaust vents, HVAC and plumbing stacks. #8 roof jack pipe boot fits 7"–13" outside diameter pipes; simply cut along the molded rings for a snug, leak-proof fit.
- HIGH-TEMP SILICONE, BUILT FOR EXTREME HEAT: Molded from high-temperature silicone EPDM rubber that can withstand temperatures ranging from -100°F to 450°F and performs in a wide service range from sub-zero winters to the heat around wood stoves and furnace vents. Flexible, weather-resistant material helps resist drying, cracking and leaks over time.
- FLEXIBLE BASE FITS METAL ROOF PROFILES: The soft rubber cone and flexible metal base conform to ribbed, corrugated and standing-seam metal roofs. Easily mold the base to match roof ribs and pitch for a tight seal on sloped roofs and around deep corrugations.
- COMPLETE INSTALL KIT – SCREWS & HEX BIT INCLUDED: Each pipe flashing boot comes with self-tapping roofing screws and a matching hex socket bit, so most installs can be completed by one person in about 30 minutes with standard tools. No need to hunt for extra hardware on the job site.
- LEAK-PROOF RESULTS WHEN SIZED & INSTALLED CORRECTLY: For best performance, always measure pipe outside diameter before ordering and choose the correct # size. To install the roof vent boot, trim it 20% smaller, seal the aluminum base with silicone, press it onto the roof, and secure the flashing with screws. For roofs with a pitch greater than 10/12, select the next size up roof pipe boot for the same pipe diameter.( Avoid installing closer to the heat source than recommended)
Korrektur der Produktinformationen
Wenn Sie Unvollständigkeiten oder Fehler in den Produktinformationen auf dieser Seite bemerken, nutzen Sie bitte das Korrekturformular unten.
Korrekturanfrage