CONFAST 3/16" x 3-1/4" Hex Head Concrete Screw with 1 Drill Bit (100 per Box)

<p>Applications</p><p>The anchor is made from Carbon Steel, and is Blue. This anchor is designed for use in Concrete, Block, and Brick.</p><p></p><p>Environment</p><p>The anchor is designed for use in a Dry environment.</p><p></p><p>Head Style </p><p>The anchor is a Hex Washer head and is designed to allow the head to sit on top of the surface of the item being attached.</p><p></p><p>Hole Diameter/Bit Diameter</p><p>The anchor requires a 5/32" hole to be drilled in the base material (Concrete, Block, and Brick). The hole should be drilled with carbide tipped bit that meets ANSI standards and used in a hammer drill.</p><p></p><p>Driver Required</p><p>A 1/4" nut driver is required for driving the anchor into the base material.</p><p></p><p>Diameter of Anchor </p><p>The diameter of the anchor is 3/16".</p><p></p><p>Length Anchor </p><p>The length of the anchor is 3-1/4"</p><p></p><p>Thread Length</p><p>The length of the threads on the anchor is 1-3/4" in length.</p><p></p><p>Minimum Embedment</p><p>The minimum anchor embedment into the concrete is 1". Therefore, the anchor must be installed so that a minimum of 1" of the anchor is embedded into the concrete.</p><p></p><p>Maximum Fixture Thickness</p><p>The maximum fixture thickness or the maximum thickness of the material being fastened for a anchor is 1-3/4" to 2-1/4". This will ensure that the minimum embedment of 1" will be met.</p><p></p><p>Fixture Hole Diameter</p><p>The hole in the fixture or material being fastened must be larger than the designated diameter of the anchor. The 3/16" diameter anchor requires the hole in the fixture to be 1/4".</p><p></p><p>Spacing between Anchors</p><p>Each anchor must be spaced a minimum distance of 3" from each other when measured center to center.</p><p></p><p>Edge Distance</p><p>It is very important not to install the anchor any closer than 2-1/4" from an unsupported edge of the concrete.</p>

• BIT INCLUDED IN EACH BOX-Proper bit equals improved holding values and reduced cost
• SLOTTED HEX HEAD-Can be driven with a nut driver
• SELF-TAPPING-Taps threads directly into masonry and requires no other anchor
• DIAMOND POINT-Easier to drive the screw to save time