DC 12V small mini brushless water pump submersible impeller centrifugal pump large flow support PWM speed regulation

★★★★☆ 4.0 40 Bewertungen

€36.00
Preis bei Onlinekauf
Kostenloser Versand 30 Tage kostenlose Rückgabe

Verkauft und versendet von noticiasdelaquinta.com.ar
Wir bemühen uns, Ihnen genaue Produktinformationen anzuzeigen. Hersteller, Lieferanten und andere stellen die hier gezeigten Angaben bereit.
€36.00
Preis bei Onlinekauf
Kostenloser Versand 30 Tage kostenlose Rückgabe

Wie möchten Sie Ihren Artikel erhalten?
Die ersten 30 Tage sind kostenlos! Wählen Sie den Tarif an der Kasse.
Versand
Ankunft 02.10.
Kostenlos
Abholung
In der Nähe prüfen
Lieferung
Nicht verfügbar

Verkauft und versendet von noticiasdelaquinta.com.ar
30 Tage kostenlose Rückgabe Details

Produktdetails

Artikelnummer 210655771 Erscheinungsdatum 2026/04/02 Listenpreis €36.00 Modellnummer 210655771
Kategorie

PumpsSpecification:1. The voltage should not exceed DC15V, it is best to use DC12V2. The power supply current should be greater than 3A. Too small a power supply will affect the use of the water pump.3. Please add a filter at the water inlet to prevent debris from entering the water pump, which may also damage the water pump.4. This water pump should be a high temperature resistant water pump that can pump hot water. However, if it is used as a feasible water pump, the external water temperature should not exceed 50 degrees and it cannot be directly introduced into boiling water.5. The water pump cannot be self-deprecating. Before pumping water, you should pay attention to emptying the air. Completely emptying the air will also affect the power.The lead wire of the brushless water pump is a Teflon high temperature resistant wire, the lead wire is of good quality and is 4P. The driver board has reverse connection protection. The positive and negative poles are connected to the water pump but it does not work, and the driver board will not burn. The driver board also has an output signal FG line (yellow line) and a speed control line blue line (5V PWM signal). The wiring method is as follows:Red wire: connected to the positive pole of the power supply (12V)Black wire: connects the negative pole of the power supply and the negative pole of the PWM signal (GND)Yellow line: output signal FG line (just leave it hanging)Blue line: 5V PWM signal (or 5V voltage)If you only need simple operation, connect the red wire to 12V, the blue wire to the red wire through a 10K resistor, and the black wire to the negative pole. The water pump runs at the highest speed. In this way, only one set of power supply can be used normally, which is very conservative.If you need PWM signal speed regulation, input 5V PWM signal on the blue line. Please note that the voltage of PWM signal is about 5V, because if the voltage exceeds

  • Pumps
Color One Color
Brand Name XOIIIQND
Unit Count 1.0 Count
Item Weight 50 Grams
Manufacturer XOIIIQND
Model Number XOIIIQND

Korrektur der Produktinformationen

Wenn Sie Unvollständigkeiten oder Fehler in den Produktinformationen auf dieser Seite bemerken, nutzen Sie bitte das Korrekturformular unten.

Korrekturanfrage

Kundenbewertungen

4 von 5
★★★★☆
40 Bewertungen | 16 Rezensionen
So wird die Artikelbewertung berechnet
Alle Bewertungen anzeigen
5 Sterne
75% (30)
4 Sterne
8% (3)
3 Sterne
4% (2)
2 Sterne
2% (1)
1 Stern
11% (4)
Sortieren nach

Für dieses Produkt liegen derzeit keine schriftlichen Bewertungen vor.