DGT New 4nd Generation P028-II Dual Tattoo Power Supply 1 Foot Pedal 2 Clip cords

Power Up the TATTOO POWER P028-II Simple Operation P028-II VOLTAGE ADJUSTMENT: Use the up and down buttons to adjust voltage. The default adjustment resolution is 1 (1/10) volt, you can change this value in the config menu.When you adjust these values, they are stored in the power supply memory even in the event of power off. PRESETS: The power supply was set in 2 machine modes, in two machine modes there is one voltage preset for the L button and one for the S button. In the config menu,you can change to 4 machine modes, Pressing the L button will access and toggle between the two liner presets and pressing S button will access and toggle between the two shader presets. *For P028-II it is up to 6 machines modes presets* The P028-II operation is quite simple. Now, your unit is powered up and ready to use in wired, momentary foot switch operation mode. Use the (L) & (S) button to select between the liner and shader presets. Use the (+)/(-) button to adjust voltage. The pre-programmed presets are 5 volts for the liner and 7 volts for the shader. When you adjust these values it is stored in the power supply memory even in the event of power off. STOP WATCH operation: The clock button performs four functions: start/stop, resume and reset. When the stop watch is not counting, pressing the button starts or resumes the clock count. When counting, pressing the button stops the count but does not reset it. When pressing and holding the clock button for approx, 3 seconds the stop watch will reset. The stop watch will not count when power supply is in sleep mode. CONFIGURATION MENU, press and hold the (L) and (S) buttons at the same time for approx. 3 seconds. SW Switch: The SW button performs Switching between 1 Machines and 2Machine.

• Dual imput Tattoo Power Supply
• Good for Rotary Tattoo Machine
• Output 0-18v, 2.3Amp
• Come with Foot pedal and Clip cord
• 4 Memory Setting / Build in Footswitch mode