HILLHOME High Torque I Shaft Hands Quartz DIY Wall Clock Movement Mechanism with 9.1 Inch Long Spade Hand Battery Operated Repair Parts Replacement, 5/8 in Max Dial Thick, 1-1/10 in Total Length

Features:Good clock replacement: This kit is good size replacement both in terms of the shaft and the size of the hands. It can be a replacement for your broken clock. Simple style clock movement: It can match to diverse colors, patterns,shapes clock panel, it will not stand out, good movement will work well. Simple design, easy to use. Wide application: You are enable to use it to repair,replace or make a clock; Applicable to cross-stitch, three-dimensional embroidery, craft clock, frameless draw clock, etc. Material: plastic and aluminumSecond hand motion: JumpAccuracy Within ±30 seconds deviation each month (in normal temperature)Power: 1.5 V AA 1 x battery (not included) Please DO NOT USE Alkaline battery,Rechargeable batteries,they will damage the movement.Dimensions:Case size: approx. 56 x 56 x 17 mm (2.2 x 2.2 x 0.67 inches)Package included:1 x Quartz clock movement1 x Minute hand1 x Hour hand 1 X Plastic washer1 X Brass washer1X Brass nut1 x Metal hook1 x User manualKindly note:- The hour and minute hands had a protective plastic coating that needs to be carefully removed. - Be careful not to bend the hands with too much pressure. - Do not tighten the brass hex nut too tight- Press hard to get all clock hands in place- Check if all hands are aligned- Check the size before buying.

• ✔️ High torque clock movement with metal hook: I shaft, drive long clock hands (10 mm to 450 mm), with 230 mm/ 9.1 inch long hand to fit dials up to 56 cm/ 22 inches in diameter. Good for repairing, replacing or making a clock by yourself. The simple style clock movement can match to diverse colors, patterns, shapes clock panel, it will not stand out, good movement will work well.
• ✔️Accurate time-keeping motor:Size- total shaft length is 28 mm (1-1/ 10 inch), thread length is 19 mm (3/ 4 inches), suitable for 12 - 16 mm (12/ 25 - 5/ 8 inches) thickness clock panel; Jump second movement, high torque motor available. Features high precision clock mechanism, which offers watchmaker's accuracy and dependability; powered by a AA battery.
• ✔️Size from the center of the hole to the tip: the hour hand is approx. 175 mm/ 6.9 inches long; The minute hand is about 230 mm/ 9.1 inches in length.
• ✔️ Compatible clock: applicable to cross-stitch, three-dimensional embroidery, craft clock, frameless draw clock, and especially suitable for DIY quartz wall clock replacement movement parts, etc. INSTRUCTIONS - Included along with the movements.
• ✔️ Warm notice: when you install this clock movement kit, please keep the hour hand and minute hand parallel, and please check the sizes before buying.