Japan 20W DC5V-26V PWM 11000rpm Outer rotor brushless motor For Sweeper - (Speed(RPM): motor)

Voltage: DC5V ~ 26VBuilt in driver,PWM adjustable speed,Can be reversed(the short-circuit solder joint has been reserved on the motor drive board),Speed signal output(10K resistor needs to be pulled up),Six pulses per revolution,The positioning or constant speed drive can be done by MCU or PLC programming.Design the motor used in the For Intelligent sweeping robot,Though small in size,But the maximum power is 20W,High speed motor,But because of the outer rotor and rare earth permanent magnet, the torque is good.The cable is free.The following are the current and speed tested at 5V, 12V and 24V:5V voltage, no-load current: 60mA, no-load speed: 2200 rpm.12V voltage, no-load current: 100mA, no-load speed: 5200 rpm.24V voltage, no-load current: 160mA, no-load speed: 11000 rpm.Net weight: 30gRotation direction: default counterclockwise(it can be reversed and clockwise)Red line: motor drive power positiveBlack wire: negative pole of power supplyYellow line:PWM speed control line,External PWM signal speed regulation,Frequency 15-25khz,Adjust the cycle to adjust the speed.Green line:Speed signal output line,Output square wave signal,It is necessary to pull up 10K resistor positive potential,Six pulses per revolution.Be careful:The positive and negative poles of the power supply of the BLDCM shall not be connected reversely, otherwise the drive will be burnt out.The power supply and PWM speed regulating signal of the motor shall be connected at the same time,It is impossible for the motor to run when the motor power is connected first and then the PWM speed regulating signal is connected,After the motor is running, do not adjust the speed to the minimum until the motor stops.Otherwise, you need to restart the power supply to turn on.

• Speed(RPM): motor