Kegerator Tap Tower Kit CGA-320 Kegerator Regulator 10ft Beer CO2 Gas Line with OD 5/16" Barb Fittting

Kegerator Tower Kegerator Regulator Beer CO2 Gas Line

• Full Set Of Kegerator Replacement Parts Kit: This single faucet beer tower kit comes with a 3” stainless tower, 5ft beer line, faucet spring, beer faucet, faucet cover, faucet brush, tap handle, screws, washer and nuts, 1/4" barb connector, hose clamp, faucet wrench, and gasket. Provide everything you need for the Kegerator and countertop installation.
• Pre-Installed Accessories: The 5ft 3/16’’ ID beer lines and beer tap shank are pre-installed in the beer tap tower to save you time. You can install your single-tap beer tower into your kegerator or countertop in just minutes.
• Threaded Quick Disconnect: Threaded barb keg regulators are equipped with a 1/4'' swivel nut that allows the CO2 regulator to be used with hose sizes of 1/4“ and 5/16” I.D
• Precise & Clear Gauges: Our CO2 pressure regulators are built to last. The left gauge (0-3000psi) can monitor the amount of CO2 in the tank at any time, and the top gauges are output pressure(0-60psi). The keg pressure can be accurately fine-tuned while avoiding damage to the pressure gauge due to excessive pressure
• 10 Feet CO2 Gas Line Hose: A 10-foot kegerator gas line offers flexibility in setting up your beer dispensing system. You can cut the beer keg gas line to any desired length for your Sankey keg tap system and Cornelius ball lock kegging system. Provides great flexibility and convenience for your multiple kegging needs