Magnetic Cable Management Small Arch - VHB Plate (5-pack)

★★★★☆ 4.0 127 Bewertungen

€2.40
Preis bei Onlinekauf
Kostenloser Versand 30 Tage kostenlose Rückgabe

Verkauft und versendet von noticiasdelaquinta.com.ar
Wir bemühen uns, Ihnen genaue Produktinformationen anzuzeigen. Hersteller, Lieferanten und andere stellen die hier gezeigten Angaben bereit.
€2.40
Preis bei Onlinekauf
Kostenloser Versand 30 Tage kostenlose Rückgabe

Wie möchten Sie Ihren Artikel erhalten?
Die ersten 30 Tage sind kostenlos! Wählen Sie den Tarif an der Kasse.
Versand
Ankunft 01.10.
Kostenlos
Abholung
In der Nähe prüfen
Lieferung
Nicht verfügbar

Verkauft und versendet von noticiasdelaquinta.com.ar
30 Tage kostenlose Rückgabe Details

Produktdetails

Artikelnummer 236110030 Erscheinungsdatum 2026/07/09 Listenpreis €2.40 Modellnummer 236110030
Kategorie

WARNING: VHB should be considered a "permanent" adhesive - removing VHB tape after it has been applied may cause damage to paint or other surfaces.

Magnetic Cable Management VHB Plates are an optional upgrade for standard Magnetic Cable Management plates. 3M VHB is a legend in the industry for a reason - their adhesive is second to none. We always recommend screwing your plates into your desk or wall for maximum hold, but if you insist on only using an adhesive solution... VHB is the way to go.

Includes:
- 5 Small VHB Steel Plates

HOW TO INSTALL

  • Clean your mounting surface with 70% isopropyl alcohol or soap and water solution to remove any dirt or oil that may interfere with the adhesive backing. 
  • Peel the backing layer off a loose plate (or magnetically connected plate and arch) to expose the adhesive. 
  • Press the plate (or connected plate and arch) against the surface in the desired location. 
  • Apply firm pressure to the plate or arch against the mounting surface for at least 10 seconds. 
  • For maximum security, screw your plate into your mounting surface with the included screws. 
  • For more detailed installation instructions, please refer to 3M's installation documentation here.

If you used a Magnetic Arch to help position your adhesive plate: 

  1. Carefully remove the arch from the plate (Tip: reaching inside the arch to hold the plate against the surface while sliding the arch sideways can be helpful) 

  2. Ensure good contact between the entire plate to the mounting surface by firmly pressing all areas of the plate against the mounting surface.

Disclaimer: This only comes with the VHB plates for the Small Arches. Arches are sold separately. See "Related Products" below.


Korrektur der Produktinformationen

Wenn Sie Unvollständigkeiten oder Fehler in den Produktinformationen auf dieser Seite bemerken, nutzen Sie bitte das Korrekturformular unten.

Korrekturanfrage

Kundenbewertungen

4 von 5
★★★★☆
127 Bewertungen | 52 Rezensionen
So wird die Artikelbewertung berechnet
Alle Bewertungen anzeigen
5 Sterne
75% (95)
4 Sterne
8% (10)
3 Sterne
4% (5)
2 Sterne
2% (3)
1 Stern
11% (14)
Sortieren nach

Für dieses Produkt liegen derzeit keine schriftlichen Bewertungen vor.