Mechanical Float Switch, Pump Down, without Piggyback Plug, 20FT Cable, Controling Waste Water and Sewage Level, Suitable for Pumps of 0.75HP and Below

This is a PUMP DOWN switch, used to control the sump pump to drain water out of well. It senses changes in water level and automatically turns on/off. It is simple to install and can be used with sump, sewage, or effluent pumps.

• Pump down: When the water level is high, the switch is turned ON, and the pump starts to discharge excess water and control the water volume When the water level is low, the switch is turned OFF, and the pump stops working. WARNING: IT'S A PUMP DOWN SWITCH, NOT A PUMP UP ONE.
• These mechanically-activated, wide-angle switches provide automatic control of pumps in waste water and sewage applications. It detects the waste water and sewage level and automatically turns ON/OFF, to control the sump, sewage, or effluent pump to START/STOP working.
• Waterproof: The float is tightly sealed to prevent water from entering. It provides long life and reliable quality. The switch can operate in water with a maximum temperature of 60℃
• Widely Application: The float switch is maily used in waste water and sewage system, it also can be used in basements, water tanks, and etc.
• This is a mechanical float switch with Non-mercury design.
• The cable is flexible SJOW, water-resistant (CPE) cable, 16awg, 2 conductors, 20ft. The rating voltage is 120/240VAC.
• IT IS SUITABLE FOR PUMPS OF 0.75HP AND BELOW, PLEASE DON'T BUY IF YOUR PUMP IS OVER 0.75HP.