Taper and Deburring Countersink Small, Ø: 1.5, rated Diameter: 6.3 CM

Taper and Deburring Countersinker DIN335–C D 90Grad 0.02 inch (.6,3 mm) 3Schneiden HSS Drill Bit HSS-TiAIN DIN 335 - C 3 Cut Straight Shank Countersink 90° clockwise for burr-free and judder-free countersinking, deburring and sinking Best results at low cutting speed higher surface hardness approx. 3000 HV to Trockenbearbeitung for steel, cast, coloured and light metals

• Shank: 6.3 mm; Tip: 1.5 mm; Length: 45 mm; Head: 5 mm
• Cutting with split point DIN 1412 °C, cutting angle 118 point, angle cut cone 20/30, right
• The CBN grinding and the design of the chip output channels ensure optimal fit without noise, vibration and burrs.
• Suitable for non-ferrous metals, steel, thermoplastic and hard plastics, as well as sheets of metal up to 4 mm thick
• Special coating of titanium nitride Black, lets you work without cooling; with cooling, get better results than the gold titanium