Trend Networks R156005 SignalTEK NT Network Transmission Tester Kit

TREND Networks

R156005

Network Transmission Tester Kit

Network Tester / Carrying Case / Power Supply & Charger / RJ45 Patch Cable Kit

Retail

783250800933

Proposition 65 Warning

NCNR - Non-Cancellable / Non-Returnable

Blue / Black / Gray

ABS

Installation Testing / Cabling:

Network traffic performance test on copper and fiber to IEEE802.3ab standard

Wiremap test for open, shorts, miswires and split pairs to TIA-568 standard

Gigabit link verification for copper and fiber cabling

Active Network:

Network load testing through switches simulating CCTV/IPTV/VoIP/Web traffic

PoE/PoE+ verification that displays available voltage at device location

Check Ethernet connectivity at device location to 10/100/1000 Mb/s

Verify network configuration (device IP/gateway address/subnet mask)

Switch port identification via LLDP/CDP protocols

Troubleshooting / Diagnostics Cabling:

Distance to fault using TDR technology (copper only)

Ability to identify and trace cables with a compatible amplifier probe

Optical power indication (with compatible SFP modules)

Active Network:

Network load testing through switches simulating CCTV/IPTV/VoIP/Web traffic

Stress test network before installing bandwidth hungry devices

Port blink to visually trace cable from work area outlet to network switch

Displays port ID of LLDP/CDP enabled switches to eliminate manual cable tracing

Identify network connection problems as hardware, network or configuration faults

Ping local network devices and Internet URL’s

Count number of hops between network points with traceroute tests

PoE load testing to confirm available power meets PoE device requirements

Applications:

SignalTEK NT is used to quickly prove that Ethernet will work correctly after installation in cable installations such as SOHO or residential cabling where cable certification is cost prohibitive or where the end customer does not require the cable manufacturer’s warranty programs.

Workstation or Laptop has an extremely slow network access. SignalTEK NT can be used to run a simplified transmission test to check network performance

A 100Mb/s LAN environment gets upgraded to 1 Gb/s. SignalTEK NT can be used to check if the existing (old) cabling can support up to 1Gb/s Ethernet

An existing LAN installation gets upgraded to VoIP. SignalTEK NT can be used to check if both the cabling as well as the active components can support VoIP traffic

After MACs (Moves/Adds/Changes) of active devices, SignalTEK NT can be used to ensure minimum bandwidth requirements are met.

In industrial Ethernet applications, SignalTEK NT can be used to verify cabling performance to 100Mb/s or Gigabit requirements

SignalTEK NT can be used to test throughput of an industrial Ethernet LAN