TRUKD V2 12.5" Accessory Panel

Our full-length 52" long panels span from bar to bar and allow you to strap everything you need to the side of the TRUKD bed rack! They adjust 2.5 in increments each way to allow for the maximum flexibility of your crossbar locations. These panels bolt directly onto the TRUKD 12-inch brackets by simply removing the stock faceplates. Our panels are made from powder coated 3/16 powder coated aluminum to allow you to load them up and use them without fear of rust.  

These panels work great with any accessory that mounts with a 1/4-20 bolt, 1/2" bolt, or wide washer clamp, including Rotopax, Quickfist Clamps, TRUKD traction board mounts, and high lift jack mounts, and more!  Check out our accessories section to order the right hardware and the to attach your accessories.

Rotopax require backer plates or an adapter to fit the TRUKD 2" hole spacing.

This panel is compatible with 12,18, or 24" bed rack heights, but must be placed at the top of the brackets on larger racks.

Specs:
Material: 3/16th Aluminum
Length: 52 inches or 64 inches
Finish: Textured Black Powder Coat

*Not Compatible with V1 TRUKD Bed Racks,

**64 inch panels are made-to-order and will take between 4 and 6 weeks to ship